Troubleshooting

My Watch Stopped After a Drop: Shock Damage to Check First

A watch that stopped after a drop may have shock damage. Learn what to check first, which seals to inspect and when to see a watchmaker before winding it again.

On this page
  1. First Steps After a Drop
  2. What a Hard Knock Can Damage
  3. Signs That Point to Shock Damage
  4. Mechanical and Quartz Watches After a Drop
  5. Check the Seals Too
  6. Shock Protection Features
  7. When to See a Watchmaker
  8. Preventing Drop Damage
  9. Frequently Asked Questions

First Steps After a Drop

Before you try anything else, look the watch over.

  1. Stop trying to wind or set it. Pulling, pushing or turning the crown on a damaged watch can make the damage worse.
  2. Check the crown position. Make sure the crown is fully pushed in or screwed down. If the crown won’t move as it should, a crown that won’t wind covers the safe checks.
  3. Look at the hands. Check whether a hand is bent, loose or touching the dial or crystal.
  4. Look at the crystal and case. A crack, a chip or a loose bezel is worth noting, because the seals may be affected.
  5. For a quartz watch, check the battery contact. A knock can loosen the battery or its clip. If you’re comfortable doing so, check the battery is seated. Don’t force anything.

What a Hard Knock Can Damage

A drop can damage parts inside the movement. Common examples include:

  • The balance staff and pivots. These are very fine parts that hold the balance wheel. A hard knock can bend or break a pivot.
  • The hairspring. A knock can move the hairspring out of position or bend it, which affects the balance.
  • The mainspring. A mainspring can break or come loose after a knock.
  • The escapement. The pallet fork and escape wheel can be knocked out of alignment, and the balance can overbank. Why your watch is losing or gaining time covers overbanking in more detail.
  • Gear teeth and jewels. These can chip or move.

On a quartz watch, a drop can affect the battery contact, the circuit, the stepping motor, the hands or the crystal.

Signs That Point to Shock Damage

  • The watch stopped right after the drop and won’t restart.
  • It rattles or makes a new noise.
  • A hand is bent, loose or touches the dial.
  • The watch runs erratically, or the rate has changed sharply.
  • A quartz second hand is stuck or jumps irregularly after a fall.

These signs don’t tell you exactly what’s wrong. They do suggest the watch needs a professional look rather than repeated attempts at home.

Mechanical and Quartz Watches After a Drop

  • Mechanical watches are more likely to need a service after a hard knock. A watchmaker may need to check the balance, hairspring, escapement and mainspring.
  • Quartz watches may recover after a battery check and a reseat of the contacts. A damaged circuit or stepping motor needs a service.

Check the Seals Too

A hard knock can damage the crystal, the crown or the case back. If the watch is water-resistant, the seals may no longer keep out water. Look for fog or droplets under the crystal, and see condensation inside a watch crystal for what to do. A pressure test after a drop is a sensible step if the watch is meant to be water-resistant.

Shock Protection Features

Many mechanical movements include shock protection for the balance staff, such as Incabloc or a similar system. This reduces the risk of damage in ordinary knocks, but it doesn’t remove the risk. A hard enough fall can still damage parts. Shock protection is designed mainly for the balance staff, not the whole watch.

When to See a Watchmaker

Take the watch to a watchmaker if:

  • It stopped after a drop and won’t restart with a normal wind or battery check.
  • It makes a new noise, such as a rattle.
  • A hand is bent or touches the dial.
  • The rate changed sharply after the drop.
  • Fog or droplets appeared under the crystal, or the watch was submerged after the fall.

Ask for the watch to be checked and pressure-tested before you wear it again.

Preventing Drop Damage

  • Set the watch down on a soft surface, not a hard counter or bench.
  • Take extra care when changing the strap or removing the watch.
  • Have the crystal, case and seals checked during routine service.

Frequently Asked Questions

Can I wind a watch that stopped after a drop? Only gently, and only if the crown moves freely and the watch shows no other signs of damage. A forced crown can make things worse. If in doubt, get it checked first.

Is it safe to keep wearing a watch after a drop? If it restarts, keeps reasonable time and shows no damage, it may be fine. A quick check by a watchmaker after a hard fall is still a sensible precaution.

Does a drop always mean a service? Not always, but a watch that stopped or changed its behavior after a drop should be checked. Why your watch keeps stopping gives a wider checklist.

The complete guide to troubleshooting

Why Your Watch Keeps Stopping (and How to Fix It)
Read the guide

Keep exploring

Guides from other topics

All topics →