Troubleshooting

Magnetized Watch: Why It Runs Fast and How to Demagnetize It

A magnetized watch usually runs fast because its hairspring coils stick together. Learn how to test for magnetism, demagnetize it safely and when to get help.

On this page
  1. A Magnetized Mechanical Watch Usually Runs Fast
  2. Why Magnetism Affects a Watch
  3. Signs Your Watch Is Magnetized
  4. How to Test for Magnetism
  5. How to Demagnetize It
  6. What to Avoid
  7. When a Watchmaker Should Look at It
  8. Preventing Magnetization
  9. Frequently Asked Questions

A Magnetized Mechanical Watch Usually Runs Fast

If a mechanical watch starts gaining time, a common cause is a magnetized hairspring. The hairspring is a fine spiral that controls the swing of the balance wheel. When it’s magnetized, its coils can stick together, and the watch runs faster than it should. The balance often swings less widely too, which is called lower amplitude.

Why Magnetism Affects a Watch

Mechanical watches are sensitive to magnetic fields because the hairspring is metal, and its coils need to spring apart freely. Everyday objects can magnetize a watch. Speakers, some phone and laptop components, magnetic clasps and magnetic chargers are common sources.

Quartz watches are affected differently. Their stepping motor responds to magnetic fields, so a strong magnet near a quartz watch can stop the second hand. Once the magnet is moved away, the hand usually starts again. This is a temporary effect, not the same problem as a magnetized hairspring.

Signs Your Watch Is Magnetized

  • It runs fast, gaining a noticeable amount each day.
  • It runs erratically, changing rate without warning.
  • The second hand sticks or moves unevenly.
  • It stops suddenly, especially near a magnetic device.

These signs don’t prove magnetism on their own. A dirty movement, low power or another fault can cause similar symptoms, so test the watch before deciding. If the error is large, why your watch is losing or gaining time explains how to measure it over several days.

How to Test for Magnetism

  • Use a compass. Place a standard analog compass on a flat surface and hold the watch near it. If the needle moves or follows the watch, the watch may be magnetized. Keep the compass away from speakers and phones, since they can disturb it.
  • Use a magnetometer app. Many smartphones have a magnetometer, and several apps display the magnetic field strength. Move the watch slowly near the phone and look for sharp changes. Read the app’s instructions, since sensor positions vary by phone.

Other electronics and the phone’s own parts can mislead these tests. Test in a space away from speakers and chargers, and compare readings before and after.

How to Demagnetize It

A demagnetizer is a small electric device that produces a changing magnetic field, which gradually weakens the magnetism. Follow the device’s instructions. In general:

  1. Stop the watch if the device requires it. Some guides suggest stopping the movement first. Check your device’s instructions.
  2. Place the watch on or just above the device, as directed.
  3. Press and hold the button, then slowly lift the watch straight up and away from the device over a few seconds.
  4. Release the button only once the watch is well away from the field. Releasing too early can leave the watch magnetized.
  5. Test again with the compass or app.
  6. Repeat only if needed, and don’t repeat it many times in a row.

What to Avoid

  • Don’t use a strong DIY magnet. A strong magnet can make the magnetism worse, not better.
  • Don’t put a quartz watch on a heavy industrial demagnetizer. Some industrial units are too strong for electronic watches. Use a device designed for watches.
  • Don’t keep trying. If a few cycles don’t help, stop and get the watch checked.
  • Don’t open the case to demagnetize it. Opening the case risks the seals and lets dust in.

When a Watchmaker Should Look at It

Take the watch to a watchmaker if:

  • It’s still running fast after demagnetizing.
  • It stopped or behaved erratically after being near a magnet.
  • You suspect the hairspring is damaged.
  • It has other symptoms, such as a noisy movement or a sudden change after a drop. My watch stopped after a drop covers what to check first.

A watchmaker can demagnetize the movement, check the hairspring and regulate the watch afterward.

Preventing Magnetization

  • Keep the watch away from speakers, especially powerful ones, and from magnetic clasps on bags.
  • Be careful with magnetic chargers and accessories, and don’t leave a watch resting on them.
  • Store watches apart from magnets, such as those in cases or boxes.

Frequently Asked Questions

Does magnetism make a watch run fast or slow? Usually fast. Strong magnetism can also make a watch behave erratically.

Can you demagnetize a quartz watch? Quartz watches are usually affected only while a magnet is near. If the watch keeps stopping after the magnet is removed, get it checked. Quartz watch problems covers the common causes.

Can I leave the watch near a magnet to demagnetize it? No. A magnet can make the magnetism worse, and a magnetized movement needs the right device.

The complete guide to troubleshooting

Why Your Watch Keeps Stopping (and How to Fix It)
Read the guide

Keep exploring

Guides from other topics

All topics →