Troubleshooting

What could be the reasons why my quartz watch has stopped working?

A quartz watch that has stopped usually has a battery, contact, hand or moisture problem. Here is an ordered checklist of likely causes and safe first checks.

On this page
  1. Short Answer: Usually the Battery, a Contact or a Stuck Hand
  2. Check These First
  3. Causes Inside the Watch
  4. Quick Tests You Can Do Safely
  5. When a New Battery Doesn’t Help
  6. Water-Resistant Watches Need a Seal Check

Short Answer: Usually the Battery, a Contact or a Stuck Hand

A quartz watch that has stopped completely most often has a battery problem, a poor battery contact, a hand that is catching or moisture inside the case. Magnetism and impact can also stop the movement. Work through the checks below in order, starting with the simplest.

Check These First

  1. Check the crown. Make sure it’s fully pushed in. A crown pulled out into the setting position can stop the movement.
  2. Check the battery. A flat battery is a common cause of a quartz watch stopping. If the second hand was jumping every two seconds before it stopped, the battery is the likely cause. Quartz watch problems explains the two-second tick.
  3. Check the hands. Look for a hand that touches another hand, the dial or the crystal. A bent hand can stall the movement.
  4. Try a gentle tap. A tap can sometimes shift a loose battery or clip briefly, which suggests the problem is in the contact. Don’t hit the watch hard.

Causes Inside the Watch

  • A dead or low battery. The battery can’t supply enough power to the crystal and motor. Replacing the battery is the first fix to try.
  • A loose or corroded contact. A battery or clip that has moved, or contacts that have corroded, can break the connection. A knock may restart the watch until it’s moved again.
  • A hand that catches. A hand rubbing the dial, the crystal or another hand can stall the stepping motor.
  • Moisture or corrosion. Humidity or a leaking old battery can corrode the circuit or contacts. Condensation inside a watch crystal explains what fog under the glass means.
  • Magnetism. Strong magnets can stop the second hand while they’re close. The watch often starts again once the magnet is moved away. A magnetized watch covers the mechanical case.
  • Impact damage. A hard drop can shift gears, damage the circuit or loosen parts. What to check after a watch stops following a drop covers this.

Quick Tests You Can Do Safely

  • Watch the second hand. A stopped second hand with a healthy battery may point to a movement or contact fault. A second hand that jumps suggests a power problem.
  • Check the battery code. If you’re replacing the battery, match the code printed on the old cell. Don’t guess.
  • Plan for the seal check. If the watch is water-resistant, have the seals checked when the case is opened.

If you aren’t comfortable opening the watch or changing the battery, leave that step to a jeweler or watchmaker.

When a New Battery Doesn’t Help

If the watch still doesn’t run after a new battery, the movement may need cleaning, demagnetizing or replacing. The circuit or stepping motor may be faulty, or the contacts may need reseating. A watchmaker can test these.

Take it in promptly if the watch is water-resistant and has shown fog, moisture or a sudden change after an impact, because water damage can get worse with time.

Water-Resistant Watches Need a Seal Check

When a battery is replaced in a water-resistant watch, the gasket should be checked and the case pressure-tested. A watch that has been opened to change the battery may not keep out water as well as before. This is a common reason to take a battery change to a watchmaker rather than doing it at home.

For the wider picture, including mechanical watches, see why your watch keeps stopping.

The complete guide to troubleshooting

Why Your Watch Keeps Stopping (and How to Fix It)
Read the guide

Keep exploring

Guides from other topics

All topics →