To open your watch and replace the battery, first work out which case back type it has: snap-on, screw-down or screwed-plate. Then use the matching tool. A thin blade in the notch opens a snap-on back, a case back wrench or friction ball opens a screw-down back, and a small screwdriver removes the screws on a screwed-plate back. If the back won’t move, stop and check it rather than forcing it.
Step 1: Check the watch has a battery
Quartz watches run on a battery, and many say “Quartz” on the dial or caseback. A mechanical or automatic watch has no battery to replace. If you’re not sure which type you have, check the manual before you open anything.
It’s also worth checking whether the battery really is the problem. The signs are in signs your watch battery is dying.
Step 2: Find out which back type you have
Use good light and a magnifier, then compare the back with these descriptions:
- Smooth back with a tiny lip or notch along the edge: snap-on.
- Round back with small notches around the outside: screw-down.
- Flat back held by four or more tiny screws around the edge: screwed-plate.
Step 3: Open a snap-on back
Put the watch face-down on a soft cloth. Slide a thin, non-marking blade, such as a case knife or a thin flathead screwdriver, into the notch. Lever gently, working around the edge, and lift the back off when it releases. Keep the blade away from the crown and lugs.
Step 4: Open a screw-down back
Set a case back wrench’s pins into two opposite notches, or press a rubber friction ball firmly onto the back. Press down so the tool doesn’t slip, then turn counter-clockwise. Scissors tips in two opposite notches can work as a stand-in, but they slip easily. Stop if the tool slips.
Step 5: Remove a screwed-plate back
Use a precision screwdriver that fits each screw head exactly. Remove the screws one at a time and keep them in a small dish. Lift the back plate straight off, so it doesn’t catch the gasket.
If the back won’t budge
- Check the notch and try a different point on the edge.
- Don’t use pliers on the edge or tap the back with a hammer.
- Stop if the case edge starts to bend or scratch.
- Some backs are fitted very tightly. A watchmaker can open them without damage.
What to do next
Once the back is off, note the battery code and swap the cell. The full method is in how to change a watch battery at home. Closing the back, including gasket and alignment checks, is covered in the case back guide.