Batteries and Cases

Signs Your Watch Battery Is Dying (and When to Replace It)

The second hand skipping, a dim display or a watch losing time can signal a weak battery. Learn the signs by watch type and how to check first.

On this page
  1. Signs in analogue quartz watches
  2. Signs in digital watches
  3. Signs in smartwatches
  4. Rule out other causes first
  5. Testing the battery
  6. When to replace it
  7. Mechanical and automatic watches

The second hand is usually the first clue. On a quartz watch, a second hand that moves in jumps instead of ticking each second is a common sign the battery is low. Other signs depend on the type of watch, from a dim display on a digital model to a smartwatch that won’t last the day.

Signs in analogue quartz watches

  • The second hand skips or jumps. Many quartz watches have an end-of-life indicator. Before the watch stops, the second hand starts moving in larger steps.
  • The watch stops. A stopped quartz watch may simply be flat, but check the crown first (see below).
  • It loses time or runs slow. If the watch falls behind again soon after you reset it, the battery is a suspect.
  • Extra functions stop or weaken. A chronograph, alarm or backlight may fail, or dim, before the time-keeping does.

Signs in digital watches

  • A dim, faint or patchy display, which can show up as weak segments or a dull screen
  • A weak backlight, or one that is slow to come on
  • Slow buttons or functions. Timers and stopwatches may lag or fail to start.

Signs in smartwatches

  • The battery drains much faster than usual, or won’t last a normal day
  • Battery health is lower than it was. Many smartwatches show battery health in their settings or companion app, so check there.

A smartwatch battery doesn’t work like a watch cell. It’s charged regularly, and its capacity falls over time. A drop in battery life isn’t always a fault.

Rule out other causes first

Before you buy a new cell, check these:

  • The crown. A crown pulled out to the time-setting position stops a quartz movement. Push it fully in and see whether the watch restarts.
  • The movement type. Mechanical and automatic watches have no battery. If one stops, it needs winding, wearing or servicing.
  • Moisture. Condensation under the crystal, or a fogged dial, points to a seal problem. Moisture can damage the movement, so have the watch checked.
  • The movement itself. If a watch stops again soon after a battery change, a watchmaker should check it.

Testing the battery

  • A battery tester. A tester that puts a load on the cell is a more reliable check than a simple voltage reading.
  • A multimeter. A fresh silver oxide cell measures about 1.55 V. A reading well below that suggests a weak cell. A meter reading on an unloaded cell can look close to normal even when the cell is nearly flat, so treat a meter as a rough check only.

If you’re not sure, a watchmaker can test the cell and the movement together.

When to replace it

  • Replace the cell soon after the second hand starts to jump or the watch stops. A flat cell left in the watch can leak and damage the movement.
  • Some people change the battery on a schedule, often about every two years, rather than waiting for a sign. This is a convenient guide, not a rule.
  • If a battery dies much sooner than expected, have the watch checked. See how long a watch battery lasts for what is normal.

Mechanical and automatic watches

Mechanical and automatic watches have no battery to replace. A manual-wind watch that has stopped can often be restarted by winding it. An automatic can be wound by hand or worn to restart. If either doesn’t restart, it needs servicing.

For the steps to change a battery, see how to change a watch battery at home. For getting the back off, see how do I open my watch to replace the battery.

The complete guide to batteries and cases

How to Change a Watch Battery at Home
Read the guide

Keep exploring

Guides from other topics

All topics →