Can You Adjust a Mesh Band Yourself?
Often, yes, for simple changes at the clasp. Removing mesh sections takes more care, and it depends on how the band is built. If the band is expensive, fragile, or unfamiliar, a watch service is a sensible choice.
Are Mesh Bands a Good Choice?
Mesh bands, also called Milanese bands, are flexible and tend to sit comfortably on the wrist. They can collect dust and fine hair, and some people find the fine links catch on arm hair. Whether that matters is a matter of preference, so try one on in person before you buy if you can.
Identify the Mesh Type
Mesh bands are built in a few ways:
- Clasp-adjusted. The main way to size the band is at the clasp, which may have a lift-up clip or a sliding mechanism.
- Screw-held sections. Small screws hold the sections together, and removing a section means removing its screws. The screws are tiny, so match the screwdriver tip exactly to the screw head.
- Tab or pin sections. Some mesh uses small tabs or pins. Treat these like a metal link bracelet, and follow any arrows marked on the band.
If you can find the manufacturer’s care sheet or instructions, read them first. Brands differ, and some mesh bands aren’t designed to be shortened by the owner.
Adjusting at the Clasp
Many mesh straps can be adjusted at the clasp. For a classic mesh clasp with a lift-up clip:
- Undo the buckle by inserting a small tool into the slot on the clasp and lifting the clip.
- Move the buckle to the new position.
- Close the clip, and check that it locks firmly.
For a sliding clasp, see the guide to adjusting a watch strap metal lock.
Removing Screw-Held Sections
Two small screwdrivers make this job much easier. Use one to hold the screw in place on one side of the section, and use the other to turn out the screw on the opposite side.
- Lay the band flat on a soft mat or cloth.
- Count the sections you need to remove, and mark them.
- Turn the screws out gently, keeping each screw with its section.
- Remove the sections, and reconnect the ends.
- Tighten the screws snugly. Small screws can strip if they’re overtightened.
- Check that the sections move freely and that the clasp still locks.
Screws are easy to lose, so work over a tray or a cloth. Removing equal numbers of sections from each side of the clasp helps keep the watch centered on your wrist.
Tab and Pin Sections
If the mesh uses tabs or pins, follow the steps for metal link bracelets in how to adjust a watch band. Check for arrows on the band before you push anything out, and don’t force a pin that won’t move.
Bering and Other Brands
Bering mesh bands vary by model and by age. Older or discontinued models may have different hardware from current straps. If your band has a brand marking or model number, check the maker’s guidance before you remove any sections.
Check the Result
- The clasp locks firmly and doesn’t open when you pull on the band
- All sections lie flat, with no gaps or raised edges
- Nothing catches on your sleeve
- The band still feels comfortable after a few hours of wear
When to Stop
Stop and get help if a screw strips, a section won’t come apart, or the mesh is kinked or bent. A jeweler or watch service can often fix the problem without replacing the whole band.