What You Need
- A spring bar tool, or a small flat tool that can press a spring bar in
- Your NATO strap, in the width that matches your watch’s lugs
- A soft cloth to work on
- Tweezers, if the spring bars are small
Check the Width First
NATO straps come in set widths, and the strap width should match the lug width. A 20 mm strap goes with 20 mm lugs. If you’re not sure of the measurement, measure your lug width before you buy or fit the strap.
Step 1: Remove the Old Strap
- Lay the watch face down on a soft cloth to protect the crystal.
- Use the spring bar tool to press the bar at one end inward, toward the middle of the watch, until that end of the strap comes free.
- Lift that end of the strap away from the lug.
- Repeat on the other side, then set the old strap aside.
Check that both spring bars are still in the lugs. If one came out with the old strap, seat it again before you fit the new strap.
Step 2: Thread the Strap
A NATO strap has a long piece and a shorter piece with the buckle and keepers. You’ll thread the long piece first.
- Hold the strap with the long piece ready to thread.
- Wrap the long piece around the top spring bar, the one near 12 o’clock, so the bar sits inside the loop.
- Run the strap down under the watch case.
- Wrap it around the bottom spring bar, near 6 o’clock, in the same way.
- Slide the watch along the strap until the case sits centered between the two bars.
Some straps print their own threading diagram, and the path can differ slightly from these steps. If the diagram differs, follow the strap’s own instructions. The principle is the same: both bars sit inside the strap loops, and the strap runs under the case.
Step 3: Lock the Keepers
- Feed the long end through the metal keeper ring on the shorter piece.
- Put the watch on your wrist and fasten the buckle.
- Tuck the leftover strap through the remaining keepers, so it lies neatly and doesn’t flap.
Step 4: Check the Fit
- Both spring bars sit fully in the lugs, and the strap doesn’t move.
- The watch sits centered on the strap.
- The strap doesn’t twist as it runs under the case.
- Give the strap a gentle tug from both ends to check that it’s secure.
Wear the watch for a short time, then check it again.
Common Problems
- The strap twists. It may have been threaded in the wrong order. Remove it and thread it again.
- The watch sits off-center. Slide the case back into the middle of the bars.
- A spring bar pops out. Check that the bar is fully seated in both lugs, and that it’s the right length.
- There’s extra strap at the tail. Tuck it through the keepers. Trim only if the strap is designed for it.
Tips
- Work over a cloth, so a dropped spring bar doesn’t roll away.
- Replace a bent spring bar. A bent one won’t seat well.
- Check the keepers now and then for wear.